KM2 Speed Clipper
Wahl®

Description:

Professional Quality 2-Speed Rotary Motor Gear Driven Animal Clipper Kit, 3000 SPM Low and 3500 SPM High. Complete Kit Includes: Clipper with 16 Foot Professional Grounded Power Cord, Size #10 1.8 Series Blade Set, Cleaning brush, Lubricating Oil. And Instructions.

Facts about blades and oiling:

• Blades not only become dull from cutting hair ‑ they are dulled by the abrasive particles on the hair, dirt. sand etc.

• Blades will not cut if abrasive particles are picked up and carried by the oil film between the blades. These particles tend to hold the blades apart and cause chewing and pulling instead of clean cutting.

• Oiling the blades performs two distinct functions:

1) Provides a low friction, very thin lubricant film between the cuffing blades so that they can take a full cuffing stroke without becoming hot from friction.

2) Flushes abrasive particles and hair out from between the blades.

   Note: If you cut into dirt, immediately wash with oil to flush out.

   WE STRONGLY RECOMMEND WAHL H-42 AS A CLEANER AND LUBRICANT.

Servicing of a Double-Insulated Appliance

In a double-insulated appliance, two systems of insulation are provided instead of grounding. No grounding means is provided on a double-insulated appliance, nor should a means for grounding be added. Servicing a double-insulated appliance requires extreme care and knowledge of the system, and should be done only by qualified service personnel. Replacement parts must be identical to those parts being replaced. A double-insulated appliance is marked with the words "DOUBLE INSULATED". 

Cleaning and general care

• Before cleaning/maintenance, switch the equipment off and remove the main plug from the socket.

• Never immerse the unit in water.

• Each time after use remove any hairs from the cutting blade using the cleaning brush.

• Clean the body of the clipper with a soft, damp cloth. Never use solvents of scouring agents.

• The cuffing head should be cleaned and oiled frequently with Wahl H-42 in order to maintain its good cuffing performance and thus ensure a long service life.

• The cuffing head should be replaced if the cutting performance is reduced after extended use despite regular cleaning and lubrication.

• During use always be sure the cord is not twisted or running over any sharp objects that might cut the cord insulation.

Cleaning the air filter Clean the air filter once a week or more often if necessary: Remove filter cover and clean air filter with cleaning brush. Snap the filter cover onto the clipper until it click locks into place.

Cleaning the air filter FIG. 1 Clean the air fitter once a week or more often if necessary: Remove filter cover and clean air filter with cleaning brush. Snap the filter cover onto the clipper until it click locks into place.

Changing the cutting head (blade) FIG. 2 The cuffing head can be removed by pressing the gray button under the blade and pushing the blade away from the housing. The clipper should be switched off before removing blades.

To refit the blade set, the clipper should be turned on and running. FIG. 3 Fit the blade into the metal guide and press it into place. There will be a definite "click" when the blade is snapped in place.



Our Terms of Use and Privacy Policy have changed. By continuing to browse this site, you agree to the Terms of Use and Privacy Policy.